Skip to content

P0096

Powertrain
Low

Intake Air Temperature Sensor 2 Circuit Range/Performance Bank 1

What could P0096 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0096 means intake air temperature sensor 2 gives a reading that doesn't make sense next to the other temperature sensors. On many turbocharged engines this second sensor sits in the intake manifold after the intercooler, often combined with the manifold pressure sensor, though its location varies by maker.

The usual test is a cold start after the car has sat for several hours: all the air and coolant temperature sensors should read close to each other. If sensor 2 is off by too much, or stuck, the code sets. Oil or soot on the sensor and connector problems are the most common reasons.

The engine computer substitutes a default value, so the car usually drives normally. Compare the readings with a scan tool before replacing anything, since a bad comparison sensor can also cause this code.

Severity

Low — MonitorThis Month

Symptoms

  • •Check engine light on
  • •Usually no noticeable change in driving
  • •Hesitation or rough running in very hot or cold weather
  • •Slightly reduced power
  • •Possible emissions test failure

Likely Causes

Sensor drifting or coated with oil or sootMost common

Oil vapor from crankcase ventilation or soot from exhaust gas recirculation can coat the sensor so it reads differently from the other temperature sensors.

Damaged or poor connectorCommon

A cracked connector or high contact resistance shifts the reading enough to fail the comparison check.

Faulty comparison sensorCommon

The computer compares this sensor with others such as the mass air flow sensor's air temperature. If that sensor is wrong, this code can set.

Heat soak or intake leakLess common

Unusual heat around the intake manifold, or a leak near the sensor, can make it read differently from the others.

Estimated Cost

DIY Repair

$20–$120
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$90–$280

Includes parts + labor

Common Fixes

  1. Compare the IAT2 reading with the other air temperature readings on a cold engine
  2. Inspect the sensor connector and wiring
  3. Clean or replace the sensor if it is coated with oil or soot
  4. Replace intake air temperature sensor 2 if its resistance is out of specification

Shop Parts

Related Codes

Still have questions about P0096?

Continue with P0096

Next: add your vehicle and symptoms. Your code carries over.