Skip to content

P0097

Powertrain
Low

Intake Air Temperature Sensor 2 Circuit Low Bank 1

What could P0097 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0097 means the signal from intake air temperature sensor 2 is below its valid range. Sensor 2 is the second air temperature sensor in the intake. On many turbocharged engines it sits in the intake manifold after the intercooler, often built into the manifold pressure sensor, and the engine computer uses it for fueling, ignition timing and boost control.

Most of these sensors are thermistors: as the air warms, their resistance and the signal voltage drop. A signal stuck near zero reads as impossibly hot air, which usually means the sensor is shorted inside or its signal wire is grounded. A few makers use sensors with a frequency output, where a low signal can also mean an open circuit.

You usually won't notice any change in how the car drives. The fix is typically a sensor or a wiring repair. Unplugging the sensor while watching live data tells you which: if the reading swings to very cold, the sensor is at fault.

Severity

Low — MonitorThis Month

Symptoms

  • •Check engine light on
  • •Usually no change in how the engine runs
  • •Scan tool shows an implausibly hot intake air temperature from sensor 2
  • •Slightly reduced power on some turbocharged engines

Likely Causes

Sensor shorted internally or signal wire shorted to groundMost common

Most of these sensors are thermistors whose voltage drops as air gets hotter. A short pulls the signal to near zero, which the computer reads as extremely hot air and flags as out of range.

Damp or corroded connectorCommon

Moisture or corrosion between the pins can bleed the signal down to ground.

Chafed harness touching groundCommon

A wire rubbed through against the intake or engine block grounds the signal.

Engine computer faultLess common

A failed input inside the engine control module is rare and only worth checking once the sensor and wiring test good.

Estimated Cost

DIY Repair

$25–$120
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$100–$300

Includes parts + labor

Common Fixes

  1. Unplug the sensor and watch the reading: if it jumps to very cold, the sensor is shorted; if not, look for a grounded wire
  2. Clean and dry the connector and check its pins
  3. Repair any chafed wire between the sensor and the engine computer
  4. Replace intake air temperature sensor 2 (often built into the manifold pressure sensor)

Shop Parts

Related Codes

Still have questions about P0097?

Continue with P0097

Next: add your vehicle and symptoms. Your code carries over.