Skip to content

P2199

Powertrain
Low

Intake Air Temperature Sensor 1/2 Correlation

What could P2199 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P2199 means two intake air temperature readings that should be close disagree too much. Many engines measure intake air temperature in two places: sensor 1 is often built into the mass airflow sensor, and sensor 2 sits further downstream in the intake or inside the manifold pressure sensor. Neither circuit has to be faulty on its own; the code is about the two readings not agreeing. The best check is after the vehicle has sat overnight, when both should read about the same as the outside air.

A drifted or dirty sensor is the usual cause, followed by a corroded connector that adds resistance to one circuit. Some makers have fixed this code with software: FCA includes it in a PCM update for the 2020 Ram 1500 with the 3.0L EcoDiesel, so ask a dealer before replacing parts on that truck.

You usually won't notice a change in how the engine runs, but the code stays on until the readings agree. Circuit faults for these sensors set their own codes, such as P0112 and P0113 for sensor 1 and P0097 for sensor 2.

Severity

Low — MonitorThis Month

Symptoms

  • •Check engine light on
  • •Usually no change in how the engine runs
  • •Scan data shows two very different intake air temperatures after the engine sat overnight
  • •Slightly worse fuel economy on some vehicles

Likely Causes

One intake air temperature sensor drifted or dirtyMost common

Each sensor can still be within its own range while reading far from the other. A sensor that has drifted with age, or one coated in oil or dirt, is the usual culprit.

Corroded connector or extra resistance in one circuitCommon

Added resistance shifts one sensor's reading without setting a circuit fault.

Engine software issueCommon

Some makers fix this code with a computer update. FCA, for example, lists P2199 in a PCM software update for the 2020 Ram 1500 with the 3.0L EcoDiesel V6.

Heat soak or a hot-air leak near one sensorLess common

A sensor mounted near a hot part, or one getting hot air from a leak, reads warmer than the other.

Estimated Cost

DIY Repair

$0–$120
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$100–$300

Includes parts + labor

Common Fixes

  1. Compare both intake air temperature readings with the engine cold-soaked overnight
  2. Check for any software update the maker lists for this code
  3. Clean and check the connectors and wiring of both sensors
  4. Replace the sensor whose reading is clearly off (it may be built into the mass airflow or manifold pressure sensor)

Shop Parts

Videos

What is P2199 Engine Code [Quick Guide]

nonda

What is P2199 : Engine Error Code Causes Explained

Auto User Guide

Code p0096, p0097 and p2199 13 chevy cruze

jim limon

Related Codes

Still have questions about P2199?

Continue with P2199

Next: add your vehicle and symptoms. Your code carries over.