RAM 3500 Common Problems & Reliability Guide
Get Your FREE AI Diagnostic Report
Enter your year for a personalized diagnosis for your RAM 3500
Overview
The Ram 3500 is the one-ton heavy duty pickup, sold as the Dodge Ram 3500 until the Ram brand split from Dodge around 2010. Unlike the 2500 it is available with dual rear wheels, and it is the truck most owners choose for fifth wheel and gooseneck trailers and for camper and service bodies, with a cab chassis version for work upfits. Cummins turbodiesels dominate, including the High Output engine, and a gas V8 is also offered. Owners search this page for diesel fuel and emissions trouble, front-end shake, transmission behavior under heavy loads and the manual transmission issues on older trucks.
Quick Summary
By Generation
Available Engines
Common OBD2 Codes
| Code | Frequency | Notes |
|---|---|---|
| P0300 | Common | Random misfire on 3500s with the 5.9L or 8.0L gas engines, often from worn ignition parts or a vacuum leak. Trucks that tow near their rating show these faults sooner. |
| P0171 | Occasional | Lean condition on the Magnum gas engines, most often a vacuum leak at the intake or a dirty airflow or MAP sensor. |
| P0420 | Occasional | Catalyst efficiency code on high-mileage gas 3500s. Check for exhaust leaks before replacing the converter. |
| P0335 | Occasional | Crankshaft position sensor circuit on the 24-valve Cummins. A failing sensor can cause stalling or a no-start. |
| P0251 | Occasional | Injection pump fuel metering fault on 1998.5-2002 Cummins trucks with the VP44 pump, often tied to weak lift pump supply pressure. Timing faults such as P0216 also appear on these trucks. |
Known Problems
On manual 3500s the nut that retains fifth gear on the NV4500 mainshaft can back off, usually while the truck is pulling a fifth wheel or gooseneck trailer. The truck suddenly loses fifth gear, and the loose gear can damage the mainshaft. Owners report repeat failures after repairs that reused the original nut, and rebuild shops sell upgraded nut and gear kits.
The headlight switch and its harness connector overheat and melt on these trucks. Owners report headlights and running lights cutting out while driving, burning smells and smoke from the dash, and switches replaced several times. A recall covered 1994-1997 light duty 3500s, and later trucks still show the same failure.
A weak lift pump leaves the VP44 injection pump short of supply pressure, and the VP44 can fail as a result. A diesel 3500 with this problem hard starts, stalls or loses power under load, which is a problem when the truck is hauling a heavy trailer. Check lift pump pressure whenever a VP44 is replaced.
On 1998.5-2002 trucks with the 24-valve 5.9L Cummins, a dowel pin in the front of the block can loosen and fall into the gear train, damaging the timing gears. The common prevention is to retain the pin when the front cover is removed.
Recalls
Operating the headlamps for a long time can cause headlamp switch failure on light duty Model 3500 trucks, causing the headlamps or park lamps to go out.
Sound deadener material inside the steering wheel could come loose from the cover and housing on certain 2000 Ram pickups.
Available Engines
Common OBD2 Codes
| Code | Frequency | Notes |
|---|---|---|
| P0300 | Occasional | Random misfire on 5.7L Hemi 3500s. A lifter tick with the misfire points to valvetrain wear. |
| P0299 | Common | Turbo underboost on the 2007.5-2009 6.7L Cummins, often a sticking turbo vane or failing actuator, and noticeable with a loaded dually. |
| P0401 | Common | EGR flow insufficient on the 6.7L Cummins from soot in the EGR valve and passages. |
| P2002 | Occasional | Particulate filter efficiency below threshold on 2007.5-2009 6.7L trucks used for light-duty trips or idling. |
| P2463 | Occasional | Soot accumulation in the particulate filter on 6.7L trucks, typically with interrupted regeneration. |
Known Problems
A bump at highway speed can set off a violent front-end shake that only calms down when you slow to about 30 mph. It affects 4x4 3500s and also shows up on dually trucks with big loads. The causes are worn track bar parts, tie rod ends, drag link ends, ball joints and wheel bearings. Chrysler recalled the left tie rod assembly on 2003-2008 4x4 trucks and the drag link on certain 2008-2009 trucks after the ball stud fractured. Replace worn parts as a set rather than one at a time.
On 2003-2007 trucks the high-pressure line to the number 4 cylinder can crack and spray diesel across the engine and underbody. Owners report repeat failures within months and several under-hood fires. Fuel on the ground, a diesel smell or a sudden miss are signs to inspect the line. Updated replacement lines are widely sold.
Early 5.9L Cummins 3500s can lose the fuel lift pump with no warning, which stalls the engine and removes power steering and brake assist. Testing fuel supply pressure is the first diagnostic step when the truck hesitates or dies.
The EGR cooler on 2007.5-2009 6.7L Cummins trucks can crack and let coolant into the exhaust. Owners see coolant loss, white exhaust smoke and EGR codes. A recall covered a silencer pad that could sag onto the cooler on 2007-2008 trucks. An independent-shop replacement runs about $1,200-$2,000.
Shop parts for this repairSoot can stick the variable geometry turbo vanes and the electronic actuator can fail, giving low boost, slow spool and limp mode.
Recalls
On certain heavy duty pickups the aluminum wheels may have excessive porosity in the center hub area, which can cause a wheel to crack.
The left tie rod assembly may break on 2003-2008 Ram 3500 4x4 trucks and 2007-2008 Ram 3500 4x2 cab chassis trucks.
The dual-stage driver frontal air bag can take in moisture over time, which could cause the inflator to rupture on 2006-2009 Ram 3500 trucks.
On certain pickups with four-wheel ABS, the control unit may cause a loss of front-to-rear brake balance and the rear brakes could lock up prematurely.
On 2007-2008 trucks with the 6.7L diesel, a silencer pad can sag and touch the EGR cooler.
On 2008-2009 trucks with Powers and Sons steering linkage, the drag link inner tie rod to pitman arm ball stud may fracture.
Available Engines
Common OBD2 Codes
| Code | Frequency | Notes |
|---|---|---|
| P0401 | Common | EGR flow insufficient on the 6.7L Cummins as soot clogs the EGR valve, a faster problem on trucks that idle while working. |
| P2002 | Occasional | Diesel particulate filter efficiency below threshold on the 6.7L Cummins. |
| P2463 | Occasional | Soot accumulation in the diesel particulate filter on the 6.7L Cummins, with repeated interrupted regeneration. |
| P0299 | Common | Turbo underboost on the 6.7L Cummins, from a sticking variable geometry turbo vane or failing actuator. |
| P20EE | Occasional | SCR NOx catalyst efficiency code on 2013 and newer DEF trucks. Check DEF quality, NOx sensors and the doser. |
| P0300 | Occasional | Random misfire on the 6.4L Hemi, which can follow lifter or cam lobe wear. |
Known Problems
Soot can make the variable geometry turbo vanes stick, and the electronic actuator can fail. On a 3500 pulling a fifth wheel the first signs are lost boost, slow spool, a whistle or grinding noise, then limp mode.
Trucks that mostly idle or make short runs can plug the particulate filter. Frequent regeneration, reduced power and filter codes follow, and regeneration fuel can dilute the engine oil. A replacement filter from the dealer is reported at about $1,500-$2,500.
Shop parts for this repairOn 3500s with the 68RFE six-speed automatic, heavy towing can cause torque converter shudder and overheating. A failed converter clutch valve can damage both the transmission and the converter, and valve body or clutch wear can trigger limp mode. Fluid service about every 60,000 miles is the usual guidance for trucks that tow.
The bolt that secures the intake heater grid can loosen on 6.7L Cummins engines, and in rare cases this can lead to engine damage. Have the hardware checked on higher-mileage diesel trucks.
Recalls
A loose snap ring inside the automatic transmission on certain 2012 Ram 3500 trucks built in mid-2012.
Incorrect information in the service and owner's manuals may cause flanged lug nuts to be over-tightened on 2012-2021 Ram 3500 and cab chassis trucks.
Inadequate welds on the front track bar frame brackets of 2013-2014 Ram 3500 trucks may allow the bracket to separate from the frame. A similar recall, 16V559000, covers 2015 trucks.
The outboard steering linkage jam nut may loosen and allow one end of the drag link to separate on 2013-2018 Ram 3500 trucks.
Concentric-brand water pumps on some 2013-2017 6.7L Cummins trucks have no vent hole and may leak coolant.
The ABS hydraulic control unit may fail, which can disable ABS, electronic stability control and traction control on 2017-2018 trucks.
Available Engines
Common OBD2 Codes
| Code | Frequency | Notes |
|---|---|---|
| P0087 | Occasional | Fuel rail pressure too low. On 2019-2020 6.7L Cummins trucks treat it seriously because of the Bosch CP4 pump issue. |
| P0299 | Occasional | Turbo underboost on the 6.7L Cummins from a sticking turbo vane or actuator. |
| P2002 | Occasional | Particulate filter efficiency below threshold on the 6.7L Cummins. |
| P2459 | Occasional | Particulate filter regeneration frequency. Owners of 2024 trucks have reported it with a check engine light that returned after dealer visits. |
| P20EE | Occasional | SCR NOx catalyst efficiency code on DEF trucks, including frozen or faulty DEF sensors. |
| P0300 | Occasional | Random misfire on the 6.4L Hemi, which can follow lifter or camshaft wear. |
Known Problems
On 2019 and 2020 diesel 3500s the Bosch CP4 high-pressure pump can fail early and send metal through the fuel system, stalling the engine without warning. NHTSA opened an investigation and Ram issued a recall, and the pump went back to the CP3 for 2021-2024. Metal in the filter, hard starting and low rail pressure are warning signs. If the pump has shed metal, repair can include the whole fuel system.
Diesel 3500s can set emissions faults from frozen DEF sensors, dirty connectors, a worn doser or a clogged EGR valve, and the truck can derate if they are left. Connector or doser cleaning costs little next to a DEF pump, which can cost about $1,900.
Soot can stick the turbo vanes and the electronic actuator can fail, causing low boost, a check engine light and limp mode.
Recalls
The fuel lines on certain 2019 diesel trucks, including cab chassis models, may leak fuel into the engine compartment.
Brake calipers may have been built with an incorrect assembly fluid that can swell the rubber seals on 2019 Ram 3500 trucks.
The high-pressure fuel pump may fail and stall the engine without warning on 2019-2020 trucks.
Pressure and heat inside the 68RFE transmission may push fluid out of the dipstick tube. A later recall, 22V835000, covers 2020-2022 Ram 3500 trucks.
An electrical short in the intake heater relay may cause a vehicle fire with the ignition on or off. A related recall, 23V060000, covers 2021-2023 trucks.
An insufficient weld in the transmission control unit can let fluid leak onto electrical parts and cause a loss of drive power.
Need help diagnosing your vehicle?
Get AI Diagnostic Report