Skip to content

P000A

Powertrain
Moderate

A Camshaft Position Slow Response Bank 1

What could P000A mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P000A means the engine computer saw the intake camshaft on bank 1 (the bank with cylinder 1) change position more slowly than it should. Variable valve timing uses an oil-driven cam phaser, fed by an oil control valve, to advance or retard the camshaft. This check doesn't look at where the camshaft ends up, only how fast it gets there over repeated adjustments.

Because the phaser runs on engine oil, the oil is the first thing to check: the wrong grade, old or sludged oil, or a low level are the usual causes. A partly blocked screen at the oil control valve, a sticky valve, or a worn phaser come next.

The engine usually drives normally, and the code is an early warning before the cam fails to reach its target at all. Start with an oil change to the correct specification and a look at the valve screen before buying timing parts.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on
  • •Often no change in how the engine drives
  • •Slight hesitation when accelerating
  • •Other variable valve timing codes may be stored
  • •Slightly worse fuel economy

Likely Causes

Wrong, worn or low engine oilMost common

The cam phaser is moved by engine oil, so oil that is too thick, too thin, sludged or low makes it follow the computer's commands too slowly.

Partly clogged oil control valve screen or oil passageCommon

A small screen at the oil control valve, or a restricted oil passage or pickup, cuts the oil flow the phaser needs to move quickly.

Sluggish oil control valveCommon

A valve that sticks or moves slowly delays the oil feed to the phaser even when the oil itself is fine.

Worn or leaking cam phaserLess common

Internal wear lets oil leak past the phaser vanes so it can't change angle at the normal rate.

Low oil pressure from a worn pump or bearingsLess common

When overall oil pressure is weak, every oil-driven actuator slows down, the cam phaser included.

Estimated Cost

DIY Repair

$40–$400
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$120–$1500

Includes parts + labor

Common Fixes

  1. Check the oil level and change the oil and filter with the grade the manufacturer specifies
  2. Inspect and clean the oil control valve screen
  3. Test the intake camshaft oil control valve and replace it if it sticks
  4. Check oil pressure and look for restricted oil passages or a blocked pickup screen
  5. Replace the intake cam phaser if the valve and oil are good

Shop Parts

Related Codes

Still have questions about P000A?

Continue with P000A

Next: add your vehicle and symptoms. Your code carries over.