Skip to content

P0011

Powertrain
Moderate

"A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)

What could P0011 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0011 means the engine computer sees the bank 1 intake camshaft running further advanced than it commanded, or the variable valve timing (VVT) system not performing as expected. Bank 1 is the side of the engine with cylinder 1. Exact wording varies by maker, but the meaning is the same.

Most of the time the cause is oil related. VVT uses engine oil pressure to move the cam, so low, old, or wrong-viscosity oil is the first thing to check. Next come the VVT solenoid and the cam phaser. A stretched timing chain is less common but more serious, because a chain that jumps can cause major engine damage.

Check the oil level and condition first, since that is cheap and often fixes it. If the oil is fine, have the solenoid, wiring and chain checked before replacing parts. Avoid long drives while the engine runs rough or rattles. Costs run from an oil change to over $1,000 for timing chain work.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Rough idle
  • •Hard starting or stalling
  • •Reduced fuel economy
  • •Misfires or reduced power
  • •Rattling noise from the engine on some vehicles

Likely Causes

Low, dirty, or wrong-viscosity engine oil35%

Variable valve timing systems run on oil pressure. Low level, sludge, or the wrong grade keeps the phaser from moving the cam where the computer asks.

Faulty VVT solenoid / oil control valve30%

A sticking or clogged solenoid (or its screen) cannot direct oil to the phaser correctly, so cam timing stays off target.

Stretched timing chain or worn tensioner15%

A stretched chain shifts the cam relative to the crank, which the computer reads as incorrect timing.

Failed cam phaser / actuator12%

The phaser can wear or stick internally and stop advancing and retarding as commanded.

Damaged wiring or connector to the solenoid8%

Chafed, corroded, or oil-soaked wiring can cause erratic solenoid control.

Estimated Cost

DIY Repair

$35–$500
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$1500

Includes parts + labor

Common Fixes

  1. Change oil and filter with the correct viscosity and oil level
  2. Clean or replace the VVT solenoid / oil control valve
  3. Repair damaged wiring or connectors
  4. Replace the camshaft phaser/actuator
  5. Replace timing chain, guides and tensioner

Shop Parts

Related Codes

Still have questions about P0011?

Continue with P0011

Next: add your vehicle and symptoms. Your code carries over.