Skip to content

Land Rover Range Rover Common Problems & Reliability Guide

suv
2003–2012
1 generation2 OBD2 codes4 known problems0 recalls

Get Your FREE AI Diagnostic Report

Enter your year for a personalized diagnosis for your Land Rover Range Rover

Land Rover Range Rover

No account required · Takes 30 seconds

Overview

This page covers the third-generation Range Rover (L322), sold in the US from the 2003 to 2012 model years. Early trucks used a BMW-sourced 4.4L V8; for 2006 Land Rover switched to Jaguar's 4.4L V8 and added a 4.2L supercharged V8, and for 2010 both were replaced by 5.0L V8s, with or without a supercharger. Air suspension failures are the most common serious problem at this age, and the rear hub bushings and front wishbones also wear. The 5.0L engines have Land Rover bulletins for worn timing chain tensioners and, on supercharged trucks, a worn supercharger isolator.

Land Rover Range Rover service intervals, fluids and specs

Quick Summary

Most Serious Issues

  • Air Suspension Failures
  • 5.0L V8 Timing Chain Tensioner Wear (2010-2012)

By Generation

Available Engines

4.4L V8 (BMW, 2003-2005)
4.4L V8 (2006-2009)
4.2L supercharged V8 (2006-2009)
5.0L V8 (2010-2012)
5.0L supercharged V8 (2010-2012)

Common OBD2 Codes

CodeFrequencyNotes
P0016
Occasional
Crankshaft and camshaft position correlation; on the 5.0L V8 this can be a sign of worn timing chain guides and tensioners.
P0017
Occasional
Crankshaft and camshaft position correlation, bank 1 exhaust; another timing chain wear code on the 5.0L V8.

Known Problems

The air suspension tends to fail after six to ten years. Compressors wear out, and leaking air springs or lines let the truck sag on one side or lose height when parked. Check that it moves through all three height settings quietly and stays level overnight, and look for bills showing compressor work. Some owners convert to coil springs.

Worn rear hub bushings cause a clonk over bumps, and worn front wishbones can knock under braking. Listen for both on a test drive over rough roads.

Land Rover bulletin LTB00474 (June 2014) covers a rattle or click from the front of the engine, often more noticeable at idle, on 2010-2012 Range Rovers with the 5.0L V8, supercharged or not. The cause is wear on the timing chain tensioner levers, which lets the chains lose tension. The repair is new timing chain tensioners and tensioner levers on both banks, roughly eight to nine hours of labor. Don't ignore the noise, because a chain that loses too much tension can damage the engine.

Land Rover bulletin LTB00482 (June 2014) covers a clattering, knocking or rattling noise from 2010-2012 Range Rovers with the supercharged 5.0L V8. Wear in the supercharger's torsional isolator and its spring support shaft causes excess backlash in the supercharger drive. With the belt off, a clunk or free play when the pulley is turned by hand confirms it, and the usual fix is an isolator kit rather than a new supercharger. It can be mistaken for timing chain noise, so a proper diagnosis matters. Used-car guides also report an idle rattle from the supercharger on the earlier 4.2L supercharged engine.

Need help diagnosing your vehicle?

Get AI Diagnostic Report