Skip to content

P242F

Powertrain
Moderate

Diesel Particulate Filter Restriction - Ash Accumulation

What could P242F mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P242F means the engine computer believes the diesel particulate filter (DPF) is restricted by ash. The computer compares exhaust pressure before and after the filter. After a regeneration, which burns off trapped soot, that pressure difference should drop. If it does not, the filter is assumed to be blocked by something regeneration cannot remove, namely ash.

A restricted filter reduces power and fuel economy, and the truck may go into a reduced-power mode. Over time it also stresses the turbo and engine. Frequent short trips and burning a lot of oil make it worse.

A shop should check the pressure sensor readings and attempt a forced regeneration first. If ash is the problem, the filter has to be cleaned or replaced, and replacement is the expensive end of the range. Do not delete or bypass the filter; it is illegal for road use and can bring fines.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Reduced engine power or limp mode
  • •Higher fuel consumption
  • •Frequent or failed DPF regeneration
  • •Rough idle or hard starting in some cases

Likely Causes

DPF loaded with ash that regeneration cannot burn off45%

Ash from burned oil additives is not removed by regeneration, so it builds up over many miles and restricts the filter.

Mostly short trips preventing complete regeneration20%

Without sustained exhaust heat the filter does not clean itself well, and restriction builds sooner.

Failed or damaged DPF20%

A cracked, melted or otherwise damaged filter can restrict flow and needs replacement.

Outdated PCM software or faulty differential pressure sensor10%

The computer may misjudge the restriction. Calibration updates exist for some vehicles.

Excess oil consumption or poor fuel quality5%

More oil or fuel contaminants reaching the exhaust speeds up ash build-up.

Estimated Cost

DIY Repair

$30–$500
Difficulty
Shop OBD2 scanners

Professional Repair

$200–$3500

Includes parts + labor

Common Fixes

  1. Inspect the DPF and check pressure sensor readings
  2. Run a forced (service) regeneration with a scan tool
  3. Have the DPF professionally cleaned or ash-cleaned
  4. Update PCM software where a calibration is available
  5. Replace the DPF if cleaning does not restore flow

Shop Parts

Related Codes

Still have questions about P242F?

Continue with P242F

Next: add your vehicle and symptoms. Your code carries over.