Skip to content

P0841

Powertrain
Moderate

Transmission Fluid Pressure Sensor/Switch A Circuit Range/Performance

What could P0841 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0841 means the PCM saw the signal from transmission fluid pressure sensor or switch A that was out of its expected range or did not match the commanded pressure. The sensor is how the computer checks that hydraulic pressure is what it asked for.

The cause can be the sensor itself, or a real pressure problem from low or dirty fluid, a weak solenoid or internal wear. You may see harsh shifts, slipping, or poor fuel economy, though some cars show nothing. Other transmission codes often appear alongside it.

Check the fluid first, then have the sensor, solenoid and wiring tested before anyone replaces a pump. Have it looked at this week to avoid more expensive damage.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Harsh or erratic shifting
  • •Transmission slipping
  • •Torque converter clutch not engaging or releasing
  • •Transmission overheating
  • •Reduced fuel economy

Likely Causes

Faulty transmission fluid pressure sensor or switch30%

A drifting or failed sensor reports pressure that does not match what the PCM expects.

Low, dirty or contaminated fluid25%

Poor fluid causes real pressure problems and can foul the sensor.

Faulty pressure control solenoid20%

If the solenoid cannot hold commanded pressure, the sensor reading will be out of range.

Blocked hydraulic passages or internal wear15%

Debris or worn parts reduce actual pressure.

Wiring problem or faulty PCM/TCM10%

Damaged wiring is more likely than a bad module, which is rare.

Estimated Cost

DIY Repair

$40–$400
Difficulty
Shop OBD2 scanners

Professional Repair

$200–$1500

Includes parts + labor

Common Fixes

  1. Check fluid level and condition, then replace fluid and filter
  2. Inspect wiring and connectors to the pressure sensor
  3. Replace the transmission fluid pressure sensor or switch
  4. Replace the pressure control solenoid
  5. Clear internal blockage or repair the transmission if needed

Shop Parts

Related Codes

Still have questions about P0841?

Continue with P0841

Next: add your vehicle and symptoms. Your code carries over.