Skip to content

P0671

Powertrain
Moderate

Cylinder 1 Glow Plug Circuit

What could P0671 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0671 means the engine computer has seen an abnormal reading in the glow plug circuit for cylinder 1. Glow plugs heat the combustion chamber so a diesel starts in the cold.

Expect longer cranking, white smoke on startup, rougher running until warm, and a glow plug light that stays on. The engine can still run on the other cylinders, but cold starts get harder, especially in winter.

Start with a visual check of the connector, wiring, and fuses, then test the cylinder 1 glow plug. Do not replace the relay or timer before checking the plug and wiring. If the plug is bad, the others are the same age, so some owners replace the set.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light and glow plug indicator
  • •Hard starting, especially when cold
  • •Longer cranking before the engine fires
  • •White smoke at startup
  • •Louder knocking until the engine warms up
  • •Misfire until warm

Likely Causes

Failed glow plug in cylinder 140%

A burned-out glow plug has an open circuit, which the module reports as a fault on that cylinder.

Damaged wiring or corroded connector to the cylinder 1 glow plug25%

Heat and age damage the harness and terminals near the plug.

Faulty glow plug relay or timer15%

A bad relay can cause low or no power to the circuit.

Blown fuse10%

A blown fuse may point to a short elsewhere in the glow plug circuit.

Faulty glow plug control module10%

The module monitors each plug and can fail internally.

Estimated Cost

DIY Repair

$30–$200
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$700

Includes parts + labor

Common Fixes

  1. Test and replace the cylinder 1 glow plug
  2. Repair damaged wiring or clean the connector
  3. Replace the glow plug relay or timer
  4. Replace blown fuses after finding the cause
  5. Replace the glow plug control module

Shop Parts

Related Codes

Still have questions about P0671?

Continue with P0671

Next: add your vehicle and symptoms. Your code carries over.