Skip to content

P0472

Powertrain
Moderate

Exhaust Pressure Sensor "A" Circuit Low

What could P0472 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0472 means the engine computer sees a signal from the exhaust pressure sensor that is lower than it should be. This sensor measures pressure in the exhaust, mostly on diesel and turbocharged engines, and the computer uses it to manage the turbo, the exhaust brake or pressure valve, and particulate filter cleaning.

The usual cause is a bad sensor or a wiring problem near it. The sensor sits close to the exhaust, so heat and corrosion are hard on the plug and wires. The code can also show up with the related exhaust pressure codes, and it is sometimes mistaken for an EGR problem.

You can usually drive the vehicle for a short time, but get it checked within the week. Power may drop, and if the filter cannot clean itself it can clog and leave you with a harder repair. Start with the connector and wiring, then test the sensor.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Reduced engine power
  • •Diesel particulate filter regeneration may not complete or cannot be started manually
  • •Poor throttle response or limp mode on some vehicles
  • •Hard starting or no start if the filter becomes badly clogged

Likely Causes

Failed exhaust pressure sensor40%

The sensor can fail internally and report a signal below the expected range, which sets the code.

Damaged wiring or short to ground in the signal circuit25%

Chafed or heat-damaged wires can pull the signal voltage low.

Corroded or loose connector at the sensor20%

Poor contact causes a low or dropped signal. Heat and moisture near the exhaust make this common.

Open power or reference circuit to the sensor10%

If the sensor loses its 5V supply, the computer sees a low signal.

Failed engine control module5%

Rare, and only after wiring and the sensor have been tested.

Estimated Cost

DIY Repair

$40–$250
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$600

Includes parts + labor

Common Fixes

  1. Replace the exhaust pressure sensor
  2. Repair damaged wiring in the sensor circuit
  3. Clean or replace the sensor connector
  4. Check and restore the sensor power and reference circuit
  5. Replace or reprogram the engine control module (rare)

Shop Parts

Related Codes

Still have questions about P0472?

Continue with P0472

Next: add your vehicle and symptoms. Your code carries over.