Skip to content

P0365

Powertrain
Moderate

Camshaft Position Sensor B Circuit (Bank 1)

What could P0365 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0365 means the computer detected a fault in the bank 1 camshaft position sensor B circuit, which is the exhaust cam sensor. It sees too little signal from the sensor shortly after startup.

The sensor itself is the most common cause, but check for oil leaks and wiring damage so the new part does not fail again.

Because it can cause stalling or a no-start, address it this week. A sensor replacement is usually $150 to $300 at a shop.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Loss of power
  • •Rough running or misfires
  • •Hard starting, no-start, or stalling
  • •Hesitation or sluggish acceleration

Likely Causes

Faulty camshaft position sensor B45%

The bank 1 exhaust cam sensor stops producing a valid signal.

Oil leak damaging sensor, wiring or connector20%

Oil on the connector or harness corrupts the signal.

Open or short in the sensor circuit20%

Damaged wiring interrupts the signal.

Crankshaft position sensor fault10%

The computer compares cam and crank signals, so a bad crank sensor can set this.

PCM fault5%

Rare.

Estimated Cost

DIY Repair

$25–$300
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$100–$600

Includes parts + labor

Common Fixes

  1. Replace the camshaft position sensor B
  2. Fix oil leaks affecting the sensor or connector
  3. Repair wiring or connectors
  4. Replace the crankshaft position sensor if faulty
  5. Check or replace PCM as a last step

Shop Parts

Related Codes

Still have questions about P0365?

Continue with P0365

Next: add your vehicle and symptoms. Your code carries over.