P0339
Crankshaft Position Sensor A Circuit Intermittent
What could P0339 mean for your vehicle?
Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.
P0339 means the crankshaft position sensor signal is dropping out or being disturbed for moments and then recovering. The engine computer uses that signal for spark and fuel timing, so even short dropouts can cause a stumble, a brief stall or hard starting.
A loose or corroded connector is the most common cause, followed by a sensor that fails when hot and a mounting or air gap problem. Honda recalled some 2023 Accord Hybrids for a mis-machined sensor mounting that set this code.
Because the engine can stall without warning, fix it soon.
Severity
Symptoms
- •Occasional jerking or misfire
- •Brief stalling or hunting idle
- •Hard starting
- •Check engine light on (not on every vehicle)
Likely Causes
A poor contact at the crank sensor connector or an in-line connector makes the signal drop out for a moment.
Some sensors fail intermittently once the engine is fully warm.
A loose sensor or a mounting problem changes the gap to the tone wheel.
Poorly routed aftermarket wiring or a failing ignition part can disturb the signal.
A bent or damaged tooth on the reluctor gives an irregular signal.
Estimated Cost
Professional Repair
Includes parts + labor
Common Fixes
- Inspect and clean the crankshaft position sensor connector
- Check the sensor is tight and correctly seated
- Replace the crankshaft position sensor
- Inspect the tone wheel if the fault returns
Shop Parts
Videos
Causes and Fixes P0339 Code: Crankshaft Position Sensor "A" Circuit Intermittent
HVAC Mechanic
How to Fix Slow Cranking & P0339 Error on Honda Accord (2008-2009)
Motorcar Parts of America - MPA
Related Codes
Still have questions about P0339?
Continue with P0339Next: add your vehicle and symptoms. Your code carries over.