Skip to content

P00F5

Powertrain
Low

Humidity Sensor Circuit High

What could P00F5 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P00F5 means the signal from the intake air humidity sensor is above its valid range. The sensor measures moisture in the incoming air and is usually part of the mass air flow sensor or a multifunction intake air sensor. It sends a duty-cycle signal, and a reading pinned near 100% for several seconds with the engine running sets this code.

The most common cause is the sensor itself, followed by a signal wire shorted to voltage or an open ground. Since the humidity sensor shares a housing with other intake sensors, a replacement usually means the whole combined sensor.

The engine computer substitutes a value and the car normally drives as usual, so this is not urgent. Check the wiring before replacing the sensor.

Severity

Low — MonitorThis Month

Symptoms

  • •Check engine light on
  • •Usually no noticeable change in driving
  • •Scan tool shows humidity near 100%
  • •Other intake air sensor codes may be stored
  • •Slightly uneven power or fuel economy possible

Likely Causes

Faulty humidity sensor or combined air sensorMost common

A failed humidity element in the mass air flow or multifunction intake air sensor can hold the signal at the top of its range.

Signal wire shorted to voltageCommon

A signal wire rubbing against a powered circuit drives the reading high.

Open sensor ground or signal circuitCommon

On some designs an open ground or signal wire also reads as a high signal.

Engine computer faultLess common

Rarely, the computer's input for the humidity signal fails.

Estimated Cost

DIY Repair

$60–$300
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$500

Includes parts + labor

Common Fixes

  1. Inspect the connector at the mass air flow or multifunction intake air sensor
  2. Check the humidity signal wire for a short to voltage and the ground for an open
  3. Replace the sensor assembly that contains the humidity sensor
  4. Clear the code and confirm the humidity reading is in a normal range with the engine running

Shop Parts

Related Codes

Still have questions about P00F5?

Continue with P00F5

Next: add your vehicle and symptoms. Your code carries over.