Skip to content

P00F4

Powertrain
Low

Humidity Sensor Circuit Low

What could P00F4 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P00F4 means the signal from the intake air humidity sensor is below its valid range. The sensor measures how much moisture is in the incoming air, and the engine computer uses that for its torque and emissions calculations. On the vehicles that document it, the humidity sensor is built into the mass air flow sensor or a multifunction intake air sensor in the air intake, and it reports humidity as a duty-cycle signal.

A reading stuck near 0% usually points to the signal wire shorted to ground or to a missing supply or ground. A failed sensor is the next most likely cause, and because it is part of a combined sensor, the whole assembly is usually replaced.

The car typically drives normally. Check the connector, fuse and wiring before replacing the sensor.

Severity

Low — MonitorThis Month

Symptoms

  • •Check engine light on
  • •Usually no noticeable change in driving
  • •Scan tool shows humidity near 0%
  • •Other intake air temperature codes may be stored
  • •Slightly uneven power or fuel economy possible

Likely Causes

Signal wire shorted to groundMost common

The humidity sensor's signal circuit grounded through damaged wiring pulls the reading to the bottom of its range.

Faulty humidity sensor or combined air sensorCommon

The humidity sensor is usually built into the mass air flow sensor or a multifunction intake air sensor, so a failed sensor means replacing that assembly.

Missing sensor supply or groundCommon

A blown fuse, open feed or poor sensor ground leaves the sensor unable to send a valid signal.

Engine computer faultLess common

Rarely, the computer's input for the humidity signal fails.

Estimated Cost

DIY Repair

$60–$300
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$500

Includes parts + labor

Common Fixes

  1. Inspect the connector at the mass air flow or multifunction intake air sensor
  2. Check the sensor's fuse, supply voltage and ground
  3. Check the humidity signal wire for a short to ground
  4. Replace the sensor assembly that contains the humidity sensor if the wiring tests good

Shop Parts

Related Codes

Still have questions about P00F4?

Continue with P00F4

Next: add your vehicle and symptoms. Your code carries over.