Skip to content

P0085

Powertrain
Moderate

Exhaust Valve Control Solenoid Circuit Low Bank 2

What could P0085 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0085 means the control circuit of the exhaust valve control solenoid on bank 2 reads lower voltage than expected. Depending on the maker, this oil control solenoid drives an exhaust cam phaser or a valve lift changeover. Bank 2 is the cylinder bank without cylinder 1, so the code only appears on V and flat engines.

A short to ground in the control wire is the usual cause, and on some engine computers an open solenoid winding also sets this code. When it sets, the computer turns off exhaust-side valve control or leaves it in its base position, so the engine may feel down on power and use a bit more fuel.

It is usually safe to drive to a repair shop. Check the connector and wiring first, then test the solenoid's resistance before replacing it.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on
  • •Variable valve control switched off
  • •Less power, especially at higher engine speed
  • •Rough idle possible
  • •Slightly worse fuel economy

Likely Causes

Control circuit shorted to ground or open solenoid windingMost common

A wire rubbed through to ground, or an open coil on some driver designs, pulls the control circuit voltage below what the computer expects.

Failed exhaust valve control solenoidCommon

Shorted turns inside the solenoid coil change its resistance and can set the low-voltage fault.

Corroded or oil-soaked connectorCommon

Oil and corrosion at the solenoid connector make a poor connection or a path to ground.

Engine computer driver faultLess common

A failed output stage in the engine computer can set the code once the wiring and solenoid test good.

Estimated Cost

DIY Repair

$30–$250
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$500

Includes parts + labor

Common Fixes

  1. Inspect the bank 2 exhaust valve control solenoid connector and wiring for damage, oil and corrosion
  2. Measure the solenoid's resistance and replace it if it is out of specification
  3. Repair any short to ground in the control wiring
  4. Test the engine computer output only after the solenoid and wiring pass

Shop Parts

Related Codes

Still have questions about P0085?

Continue with P0085

Next: add your vehicle and symptoms. Your code carries over.