P0079
Exhaust Valve Control Solenoid Circuit Low Bank 1
What could P0079 mean for your vehicle?
Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.
P0079 means the engine computer has found low voltage in the control circuit of the exhaust valve control solenoid on bank 1. This solenoid meters engine oil to the variable valve system on that camshaft. Depending on the engine, it moves a cam phaser that changes valve timing, or switches the valves between low and high lift. Some makers report the same valve under the camshaft position actuator codes instead. Bank 1 is the side of the engine that holds cylinder 1; on a four-cylinder engine it is the only bank.
Low usually means a short to ground: a wire rubbed through against the engine, or a solenoid with shorted windings. On some engines an open coil sets the same code. When the fault is present, the computer stops controlling that valve system and leaves it in its base position, so the engine loses some power and may idle roughly.
Check the connector and wiring at the solenoid on the exhaust side of bank 1 first, then measure the coil. It's an electrical fault rather than an oil problem, so a solenoid or wiring repair is the usual fix. Get it fixed soon, because you lose the power and economy the variable valve system provides.
Severity
Symptoms
- •Check engine light on
- •Less power, most noticeable at higher engine speeds
- •Rough or uneven idle
- •Worse fuel economy
- •Camshaft timing or misfire codes stored alongside it
Likely Causes
The engine computer sees too little voltage on the exhaust valve control solenoid circuit. A wire rubbed through to ground is the classic cause, and depending on how the computer drives the solenoid, a broken coil winding can set the same code.
Heat and age can break down the insulation inside the coil, dropping its resistance and pulling the circuit low.
The solenoid sits in the cylinder head where oil can seep past its seal into the connector and corrode the pins.
Rarely, the output inside the engine control module that switches the solenoid fails. Rule out the solenoid and wiring first.
Estimated Cost
Professional Repair
Includes parts + labor
Common Fixes
- Inspect the exhaust valve control solenoid connector and wiring for chafing, oil and corrosion
- Measure the solenoid coil resistance and compare it with the service manual value
- Replace the exhaust valve control solenoid if its coil is open or shorted
- Repair any wire shorted to ground between the solenoid and the engine computer
Shop Parts
Related Codes
Still have questions about P0079?
Continue with P0079Next: add your vehicle and symptoms. Your code carries over.