Skip to content

P0076

Powertrain
Moderate

Intake Valve Control Solenoid Circuit Low Bank 1

What could P0076 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0076 means the engine computer has found low voltage in the control circuit of the intake valve control solenoid on bank 1. This solenoid meters engine oil to the variable valve system on that camshaft. Depending on the engine, it moves a cam phaser that changes valve timing, or switches the valves between low and high lift. Some makers report the same valve under the camshaft position actuator codes instead. Bank 1 is the side of the engine that holds cylinder 1; on a four-cylinder engine it is the only bank.

Low usually means a short to ground: a wire rubbed through against the engine, or a solenoid with shorted windings. On some engines an open coil sets the same code. When the fault is present, the computer stops controlling that valve system and leaves it in its base position, so the engine loses some power and may idle roughly.

Check the connector and wiring at the solenoid on the intake side of bank 1 first, then measure the coil. It's an electrical fault rather than an oil problem, so a solenoid or wiring repair is the usual fix. Get it fixed soon, because you lose the power and economy the variable valve system provides.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on
  • •Less power, most noticeable at higher engine speeds
  • •Rough or uneven idle
  • •Worse fuel economy
  • •Camshaft timing or misfire codes stored alongside it

Likely Causes

Control wire shorted to ground, or open solenoid coilMost common

The engine computer sees too little voltage on the intake valve control solenoid circuit. A wire rubbed through to ground is the classic cause, and depending on how the computer drives the solenoid, a broken coil winding can set the same code.

Solenoid coil with shorted windingsCommon

Heat and age can break down the insulation inside the coil, dropping its resistance and pulling the circuit low.

Corroded or oil-soaked connectorCommon

The solenoid sits in the cylinder head where oil can seep past its seal into the connector and corrode the pins.

Faulty driver or supply in the engine computerLess common

Rarely, the output inside the engine control module that switches the solenoid fails. Rule out the solenoid and wiring first.

Estimated Cost

DIY Repair

$40–$200
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$450

Includes parts + labor

Common Fixes

  1. Inspect the intake valve control solenoid connector and wiring for chafing, oil and corrosion
  2. Measure the solenoid coil resistance and compare it with the service manual value
  3. Replace the intake valve control solenoid if its coil is open or shorted
  4. Repair any wire shorted to ground between the solenoid and the engine computer

Shop Parts

Related Codes

Still have questions about P0076?

Continue with P0076

Next: add your vehicle and symptoms. Your code carries over.