P0031
HO2S Heater Control Circuit Low (Bank 1 Sensor 1)
What could P0031 mean for your vehicle?
Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.
P0031 means the engine computer sees too little voltage or current in the heater circuit of the upstream oxygen sensor on bank 1. That sensor, ahead of the catalytic converter, has a built-in heater that brings it up to working temperature quickly after a cold start. Bank 1 is the side of the engine with cylinder 1.
The most common causes are a burnt-out heater in the sensor or a blown fuse on its supply. Check the fuse first, since a shared fuse can also set codes for other heated sensors.
The engine usually runs normally, but closed-loop fuel control starts late and cold-start emissions rise, so you may fail an emissions test. Replacing the oxygen sensor is the usual fix.
Severity
Symptoms
- •Check engine light on
- •Usually no change in how the engine runs
- •Higher emissions right after a cold start
- •Failed emissions or readiness check
Likely Causes
The heater inside the sensor has failed open or gone high resistance, so too little current flows.
No power is reaching the heater. A shared fuse can set several heater codes at once.
A broken or chafed wire near the exhaust stops the computer from switching the heater.
High contact resistance in the connector limits heater current.
Rarely, the computer's output for the heater fails.
Estimated Cost
Professional Repair
Includes parts + labor
Common Fixes
- Check the oxygen sensor heater fuse
- Measure the heater resistance at the sensor connector
- Replace the bank 1 sensor 1 oxygen sensor if the heater is open
- Repair damaged heater wiring near the exhaust
Shop Parts
Related Codes
Still have questions about P0031?
Continue with P0031Next: add your vehicle and symptoms. Your code carries over.