P0037
HO2S Heater Control Circuit Low (Bank 1 Sensor 2)
What could P0037 mean for your vehicle?
Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.
P0037 means the engine computer sees too little voltage or current in the heater circuit of the downstream oxygen sensor on bank 1, sensor 2, behind the catalytic converter. Depending on how the manufacturer wires the heater, that points to a short to ground in the control wire or a burnt-out heater element.
Check the fuse and the wiring under the car first, then measure the heater resistance at the sensor. A new oxygen sensor is the most common fix.
The engine usually runs normally, but the catalyst monitor may not complete, which can fail an emissions or readiness check.
Severity
Symptoms
- •Check engine light on
- •Usually no change in how the engine runs
- •Catalyst monitor doesn't complete
- •Failed emissions or readiness check
Likely Causes
Depending on the system, a short to ground or an open heater reads as low current in the circuit.
No power is reaching the heater.
High resistance in the connector limits heater current.
Rarely, the computer's output or its software is at fault.
Estimated Cost
Professional Repair
Includes parts + labor
Common Fixes
- Check the oxygen sensor heater fuse
- Inspect the downstream sensor wiring for chafing to ground
- Measure the heater resistance and replace the bank 1 sensor 2 oxygen sensor if needed
Shop Parts
Related Codes
Still have questions about P0037?
Continue with P0037Next: add your vehicle and symptoms. Your code carries over.