P0030
HO2S Heater Control Circuit (Bank 1 Sensor 1)
What could P0030 mean for your vehicle?
Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.
P0030 is a general fault in the heater circuit of the upstream oxygen sensor on bank 1, sensor 1. The engine computer switches the heater on and off and checks that the circuit behaves as commanded. When it doesn't, most often because the circuit is open, P0030 sets.
Exactly which electrical fault sets P0030 rather than P0031 (low) or P0032 (high) varies by manufacturer, but the checks are the same: fuse, wiring, connector and the sensor's heater resistance.
The engine usually runs fine, but emissions after a cold start go up and the emissions readiness monitors may not complete.
Severity
Symptoms
- •Check engine light on
- •Usually no change in how the engine runs
- •Closed-loop fuel control starts late after a cold start
- •Failed emissions or readiness check
Likely Causes
Heat and vibration near the exhaust can break the heater wiring.
The heater inside the sensor has failed.
A poor connection interrupts the heater circuit.
No supply voltage is reaching the heater.
Rarely, the computer's output for the heater fails.
Estimated Cost
Professional Repair
Includes parts + labor
Common Fixes
- Check the oxygen sensor heater fuse and relay
- Measure the heater resistance at the sensor connector
- Repair heater wiring and connector damage
- Replace the bank 1 sensor 1 oxygen sensor if the heater is open
Shop Parts
Related Codes
Still have questions about P0030?
Continue with P0030Next: add your vehicle and symptoms. Your code carries over.