Skip to content

P0023

Powertrain
Moderate

"B" Camshaft Position Actuator Circuit (Bank 2)

What could P0023 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0023 means the engine computer found an electrical fault in the control circuit of the exhaust ("B") camshaft oil control valve on bank 2. This valve is a pulse-width controlled solenoid that sends oil to the exhaust cam phaser. Bank 2 only exists on V and flat engines and is the side without cylinder 1.

When the circuit is open or shorted, the computer stops adjusting that camshaft and the phaser stays in its locked rest position. The engine keeps running but may feel weaker at low speed, idle rougher or use a little more fuel.

This is an electrical code, so start with the valve connector (oil inside it is common), then measure the valve's coil resistance and check the wiring back to the computer. Check the oil level and condition too, since the valve works on engine oil.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on
  • •Less pulling power at low and medium engine speed
  • •Rough idle or hesitation on acceleration
  • •Slightly higher fuel consumption
  • •Hard starting in some cases

Likely Causes

Failed exhaust camshaft oil control valveMost common

The solenoid coil in the bank 2 exhaust oil control valve can open or short, so the computer sees a circuit fault when it drives the valve.

Corroded, loose or oil-soaked connectorMost common

Corrosion or engine oil wicking into the valve connector acts like an open circuit.

Chafed or broken wiringCommon

The harness to the valve can rub through or break near hot engine parts, opening or shorting the circuit.

Missing supply voltageLess common

On engines that feed the valve through a fuse or relay, a blown fuse leaves the valve without power.

Engine computer driver faultLess common

The output in the engine computer that switches the valve can fail, though wiring and the valve should be ruled out first.

Estimated Cost

DIY Repair

$30–$250
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$500

Includes parts + labor

Common Fixes

  1. Inspect the bank 2 exhaust oil control valve connector for oil, corrosion and loose pins
  2. Measure the valve's coil resistance and compare it with the specification
  3. Check the wiring between the valve and the engine computer for opens and shorts
  4. Replace the bank 2 exhaust oil control valve if it fails testing

Shop Parts

Related Codes

Still have questions about P0023?

Continue with P0023

Next: add your vehicle and symptoms. Your code carries over.