Skip to content

Toyota Sequoia Common Problems & Reliability Guide

suv
2001–2022
2 generations3 OBD2 codes2 known problems2 recalls

Get Your FREE AI Diagnostic Report

Enter your year for a personalized diagnosis for your Toyota Sequoia

Toyota Sequoia

No account required · Takes 30 seconds

Overview

This page covers the first two generations of the Toyota Sequoia, a full-size, body-on-frame SUV. First-generation Sequoias (2001-2007) had front lower ball joints that could wear and separate, and Toyota recalled them twice. On second-generation Sequoias (2008-2022), the secondary air injection pumps and switching valves can be damaged by water, which turns on the check engine light, and Toyota extended coverage on 2008-2010 models.

Toyota Sequoia service intervals, fluids and specs

Quick Summary

Most Common OBD2 Codes

P2440
Common
P2442
Common

Most Serious Issues

  • Front Lower Ball Joint Wear

2 recalls documented across all generations

By Generation

Available Engines

4.7L 2UZ-FE V8

Known Problems

The front lower ball joints can wear early because of a scratched or poorly finished ball surface or a loss of internal lubrication. A worn joint gets loose, which can show up as heavier steering, a steering wheel that does not return to center well, and noise from the front end. In extreme cases the ball joint can separate from the knuckle and the driver can lose control. Toyota recalled Sequoias built from August 2001 to September 2003, and later 2004-2007 Sequoias built from September 2003 to November 2006, to replace the front lower ball joints.

Recalls

2004
Front Lower Ball Joints May Wear and SeparateNHTSA

A manufacturing problem can leave the front lower ball joint surface scratched, which can lead to excessive wear, looseness and heavier steering. The ball joint can separate from the knuckle and cause a loss of steering control. Dealers replace the front lower ball joints.

2004
Front Lower Ball Joints May Lose LubricationNHTSA

On 2004-2007 Sequoias built from September 2003 to November 2006, the front lower ball joints can lose internal lubrication and wear early, causing heavier steering, poor self-centering and noise. In extreme cases the joint can separate from the knuckle. Dealers replace the front lower ball joints.

Available Engines

4.7L 2UZ-FE V8 (2008-2009)
4.6L 1UR-FE V8 (2010-2012)
5.7L 3UR-FE V8

Common OBD2 Codes

CodeFrequencyNotes
P2440
Common
Secondary air switching valve stuck open (bank 1); usually a water-damaged switching valve or air pump.
P2442
Common
Secondary air switching valve stuck open (bank 2); same failure on the other bank.
P2443
Occasional
Secondary air switching valve stuck closed (bank 2); seen when the valve seizes from water damage.

Known Problems

Water can get into the secondary air injection pumps and air switching valves, which help clean up exhaust right after a cold start, and damage them. The check engine light comes on. Toyota extended warranty coverage of the air injection pumps and air switching valves on 2008-2010 Sequoias and 2007-2010 Tundras.

Need help diagnosing your vehicle?

Get AI Diagnostic Report