Skip to content

P2102

Powertrain
Moderate

Throttle Actuator A Control Motor Circuit Low

What could P2102 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P2102 means the engine computer sees too little current or voltage on the circuit that drives the electronic throttle motor. On many engines that means the computer is driving the motor hard but almost no current flows, which points to an open circuit or a failed motor; on others it means the motor's power supply relay isn't delivering. The computer shuts off the motor, and the throttle springs back to a fixed, slightly open limp position.

With the throttle stuck in limp position, the engine idles and will move the car slowly, but it barely responds to the pedal. That makes merging and passing unsafe, so drive only as far as you need to.

Start at the throttle body: look for water or corrosion in its connector and a broken or chafed harness, then check the throttle control relay and fuse if your engine has them. If the motor is open, the throttle body is replaced as a unit, followed by a throttle relearn.

Severity

Moderate — Address SoonToday

Symptoms

  • •Check engine light or reduced power warning on
  • •Limp mode with the throttle held at a fixed opening
  • •Engine barely responds to the accelerator pedal
  • •Low idle or stalling
  • •Traction or cruise control turned off

Likely Causes

Open throttle motor circuit or failed motorMost common

On many engines, Toyota's among them, the code sets when the computer drives the motor hard but sees almost no current flowing, which points to a broken wire, a bad connection or an open motor winding.

No power from the throttle control relay or fuseCommon

Some engines, such as Subaru's, power the throttle motor through a separate relay. A failed relay, a blown fuse or a broken supply or ground wire to it leaves the motor circuit low.

Water or corrosion in the throttle body connectorCommon

Moisture and corrosion between the pins add resistance or break the connection to the motor.

Faulty throttle driver in the engine computerLess common

The output stage inside the engine control module can fail, but only after the motor and wiring test good.

Estimated Cost

DIY Repair

$30–$450
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$800

Includes parts + labor

Common Fixes

  1. Inspect the throttle body connector and harness for water, corrosion and chafing
  2. Check the throttle motor's resistance for an open winding
  3. Check the throttle control relay and fuse where the engine uses one
  4. Replace the electronic throttle body and run the throttle relearn
  5. Repair any broken or chafed wire between the throttle body and the engine computer

Shop Parts

Videos

How To Fix P2102 Code - Throttle Actuator A Control Motor Circuit Low Repair

Car Cure

What is P2102 : Engine Error Code Causes Explained

Auto User Guide

Related Codes

Still have questions about P2102?

Continue with P2102

Next: add your vehicle and symptoms. Your code carries over.