Skip to content

P2084

Powertrain
Moderate

Exhaust Gas Temperature Sensor Circuit Range/Performance (Bank 1 Sensor 2)

What could P2084 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P2084 means the computer sees a range or performance problem with the exhaust gas temperature (EGT) sensor on Bank 1, Sensor 2. This sensor reports how hot the exhaust is. On many diesels it helps monitor the aftertreatment system, including the SCR system. When the reading is implausible, the computer stores the code and turns on the Check Engine Light.

On many vehicles you will notice nothing except the light, though some lose engine performance. The sensor is often mistaken for an oxygen sensor, which leads to parts being replaced for no reason. Because the sensor protects other exhaust components, leaving the fault alone can let a bigger problem develop.

Have it checked within a few weeks. Inspect the sensor wiring and connector for heat damage or corrosion, and look for exhaust leaks ahead of the sensor. If those are fine, the sensor itself is the usual fix.

Severity

Moderate — Address SoonThis Month

Symptoms

  • •Check Engine Light illuminated
  • •Often no other noticeable symptoms
  • •Reduced engine performance on some vehicles
  • •Related exhaust temperature or emissions system codes stored

Likely Causes

Faulty exhaust gas temperature (EGT) sensor40%

The sensor can fail internally or short, so it reports a temperature the computer considers implausible.

Damaged, burnt, or loose sensor wiring25%

The sensor sits close to hot exhaust parts, so its harness can melt, chafe, or break.

Corroded or disconnected sensor connector20%

A poor connection changes the signal voltage and looks like a bad sensor.

Exhaust leak upstream of the sensor or an aftermarket exhaust15%

A large leak or reduced back pressure from a performance exhaust can push the reading out of the expected range.

Estimated Cost

DIY Repair

$30–$200
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$500

Includes parts + labor

Common Fixes

  1. Replace the EGT sensor
  2. Repair or replace damaged or burnt wiring
  3. Clean or replace corroded connectors
  4. Repair exhaust leaks ahead of the sensor

Shop Parts

Related Codes

Still have questions about P2084?

Continue with P2084

Next: add your vehicle and symptoms. Your code carries over.