Skip to content

P0490

Powertrain
Low

Exhaust Gas Recirculation (EGR) A Control Circuit High

What could P0490 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0490 is set when the computer sees abnormally high voltage in the control circuit for EGR system A. The EGR system sends a small amount of exhaust back into the intake to cut emissions. It often appears with P0489, the low-voltage version.

Many cars show nothing besides the Check Engine Light. Some run rough, start hard, or lose power. It is mainly an emissions fault, so most vehicles can be driven while you arrange repair, though it can fail an emissions test.

Start with the wiring and connector, then watch EGR operation on a scan tool. Cleaning carbon from the valve and passages is often enough. Do not replace the valve automatically, since it is often not the failed part.

Severity

Low — MonitorThis Month

Symptoms

  • •Check Engine Light illuminated
  • •Often no other symptoms
  • •Rough idle on some vehicles
  • •Hard starting on some vehicles
  • •Loss of power on some vehicles
  • •Worse fuel economy on some vehicles

Likely Causes

Wiring or connector fault in the EGR circuit30%

A short to voltage or a bad connector can put the control circuit high.

Faulty EGR valve, solenoid, or sensor30%

An electrical failure inside the EGR valve or its position sensor can cause the high reading.

Clogged EGR or DPFE passages25%

Carbon buildup is a common culprit and can lead to a circuit fault or related EGR codes.

Faulty MAP sensor or broken vacuum line10%

On some systems these affect EGR operation and monitoring.

Faulty engine control module5%

Rare, and only after wiring and the valve have been tested.

Estimated Cost

DIY Repair

$40–$300
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$700

Includes parts + labor

Common Fixes

  1. Inspect and repair EGR wiring and connectors
  2. Clean clogged EGR valve and passages
  3. Replace the EGR valve, solenoid, or sensor if testing shows failure
  4. Check or replace the MAP sensor and vacuum lines
  5. Replace the engine control module only if confirmed faulty

Shop Parts

Related Codes

Still have questions about P0490?

Continue with P0490

Next: add your vehicle and symptoms. Your code carries over.