Skip to content

P0390

Powertrain
Moderate

Camshaft Position Sensor "B" Circuit (Bank 2)

What could P0390 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0390 means the engine computer isn't getting a proper signal from camshaft position sensor B on bank 2. Sensor B is the exhaust camshaft sensor, and bank 2 is the side without cylinder 1, so this code only appears on V-type and boxer engines with a separate exhaust cam sensor on each side.

When the signal is missing, the bank 2 exhaust cam phaser locks in its base position and the engine keeps running on the other sensors. Expect longer cranking, less power and a rough idle. Wiring, connector and sensor faults cause most cases. If the code showed up after timing chain work, check the tone wheel and timing.

Fix it soon to avoid stalling and poor fuel economy.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on
  • •Loss of power
  • •Longer cranking before starting
  • •Rough idle
  • •Higher fuel consumption

Likely Causes

Open or corroded sensor wiring or connectorMost common

A fault in the signal, 5-volt reference or ground wire of the bank 2 exhaust cam sensor.

Faulty camshaft position sensorMost common

The sensor itself has failed.

Oil contamination or a loose sensorCommon

Oil leaking onto the sensor or a loose mounting disrupts the signal.

Tone wheel damaged or misfitted after timing workCommon

If the reluctor on the phaser is damaged or installed wrong, the signal doesn't match what the computer expects.

Engine computer or a shorted 5-volt referenceLess common

Another sensor on the same reference circuit can pull it down.

Estimated Cost

DIY Repair

$25–$150
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$100–$330

Includes parts + labor

Common Fixes

  1. Inspect the bank 2 exhaust camshaft sensor connector and wiring
  2. Check the 5-volt reference and ground at the sensor
  3. Replace the camshaft position sensor
  4. Verify timing marks if the code appeared after timing chain work

Shop Parts

Related Codes

Still have questions about P0390?

Continue with P0390

Next: add your vehicle and symptoms. Your code carries over.