Skip to content

P0238

Powertrain
Moderate

Turbocharger/Supercharger Boost Sensor A Circuit High

What could P0238 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0238 means the engine computer sees the signal from turbo boost pressure sensor A reading higher than it should. That points to an open circuit or a short to power in the sensor, connector, or wiring.

You will see the Check Engine Light and probably a loss of power, since the computer may disable boost. The car is usually still drivable, but a wiring short to power can damage the engine computer, so do not leave it for long.

Get it checked this week. Look at the connector and harness for melted or broken wires, test the sensor with a scan tool, and replace the sensor if it reads wrong. Fix any wiring fault before installing a new sensor.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Reduced power during acceleration
  • •Turbo boost may be shut off by the computer
  • •Sluggish or inconsistent throttle response
  • •Possible reduced fuel economy

Likely Causes

Failed boost pressure sensor40%

An internal open circuit or fault can push the signal voltage above the expected range.

Wiring open or shorted to power30%

Damaged wiring between the sensor and the computer, often near hot exhaust parts, can cause a high signal.

Damaged or corroded sensor connector20%

A broken or corroded connector can open the circuit and give a high reading.

Faulty engine control module5%

Rare, and mainly after a short to power has damaged it.

Sensor reference voltage problem5%

A fault on the shared 5-volt supply can skew the reading, so check other sensors on the same circuit.

Estimated Cost

DIY Repair

$25–$150
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$150–$500

Includes parts + labor

Common Fixes

  1. Replace the boost pressure sensor
  2. Repair damaged wiring, checking near the exhaust manifold for melted insulation
  3. Replace broken or corroded connectors
  4. Replace the engine control module only if it is confirmed damaged, after fixing the cause

Shop Parts

Related Codes

Still have questions about P0238?

Continue with P0238

Next: add your vehicle and symptoms. Your code carries over.