Yamaha FJR1300 Common Problems & Reliability Guide
Get Your FREE AI Diagnostic Report
Enter your year for a personalized diagnosis for your Yamaha FJR1300
Overview
The Yamaha FJR1300 is a shaft-drive sport-tourer built around a 1298cc inline-four, sold in North America from the 2003 model year. It's known for covering huge mileage with little drama, but each generation has its own weak points: engine heat on the early bikes, water getting into the shaft drive and wiring, a recalled brake light switch that can also kill the cruise control, and a second-gear failure recall on the 6-speed bikes. This guide covers what owners, buyers' guides and NHTSA records document for each generation.
Quick Summary
Most Serious Issues
- Ignition Switch Wiring Failure(Free under recall; $250-$450 out of recall)
- Overheating Ground Connector in the Wiring Harness(Free under recall; $800-$1,500 for a harness out of recall)
- Second Gear Can Crack(Free under recall)
5 recalls documented across all generations
By Generation
Available Engines
Known Problems
Owners of first-generation FJRs complained about engine heat reaching the rider, especially in traffic and hot weather. Yamaha reworked the airflow, radiator and vents for the 2006 model specifically to deal with it. On a Gen I bike, aftermarket heat deflectors and keeping the cooling system and fan in good order help.
Shop parts for this repairThe FJR's shaft drive has a reputation for letting water in, and rust on the splines and joints causes clunks and wear if it's ignored. Buyers' guides recommend stripping and greasing the shaft and splines about every 30,000 miles, more often if the bike is ridden in the rain a lot.
Typical mileage: Every 30,000 miles
Shop parts for this repairAvailable Engines
Known Problems
The internal wiring of the ignition switch on 2006-2009 FJRs can disconnect, cutting power so the engine stalls and may not restart. Yamaha recalled these bikes to replace the switch. A bike that dies and comes back when the key is wiggled is the classic symptom.
Shop parts for this repairOn 2006-2009 FJRs the ground joint connector in the main wiring harness can overheat and deform, giving an intermittent ground. That can upset the ignition and other electrics and stall the engine. Yamaha's recall adds a ground sub-lead and replaces the main harness if the connector is already damaged. Intermittent stalling or flickering electrics on one of these bikes points here first.
Shop parts for this repairThe FJR's shaft drive has a reputation for letting water in, and rust on the splines and joints causes clunks and wear if it's ignored. Buyers' guides recommend stripping and greasing the shaft and splines about every 30,000 miles, more often if the bike is ridden in the rain a lot.
Typical mileage: Every 30,000 miles
Shop parts for this repairRecalls
The internal wiring of the ignition switch on certain 2006-2009 FJR1300s can disconnect, stopping current flow so the engine stalls and may not restart. Dealers replace the ignition switch.
The ground joint connector in the wire harness of certain 2006-2009 FJR1300s can overheat and deform, causing an intermittent ground that can disrupt the ignition and stall the engine. Dealers add a wire sub-lead and replace the main harness if the connector is damaged.
Available Engines
Known Problems
Silicon oxide can build up on the front brake switch contacts and raise their resistance. The brake light can then stay on all the time, and the cruise control can switch off unexpectedly. Yamaha recalled 2013-2020 FJRs to replace the switch.
Shop parts for this repairThe FJR's shaft drive has a reputation for letting water in, and rust on the splines and joints causes clunks and wear if it's ignored. Buyers' guides recommend stripping and greasing the shaft and splines about every 30,000 miles, more often if the bike is ridden in the rain a lot.
Typical mileage: Every 30,000 miles
Shop parts for this repairA breather near the exhaust headers can draw water into the fuel tank, causing rough running or stalling in wet weather. Yamaha has an official fix, so check that it has been fitted on any used bike.
Shop parts for this repairWater pools under the tank, and the wiring and connectors there are prone to corrosion. Owners report intermittent electrical faults traced to this area. Cleaning and sealing the connectors with dielectric grease is cheap insurance.
Shop parts for this repairThe rear suspension linkage bearings can seize if they aren't cleaned and greased, making the ride harsh and wearing the shock. Check for notchy movement and grease the linkage when the rear wheel is out.
Shop parts for this repairThe electrically adjustable screen mechanism can break. Run it through its full travel when buying; it should move smoothly without grinding or stalling.
Shop parts for this repairRecalls
The front brake switch on certain 2013-2020 FJR1300s (and other Yamaha models) can fail from increased resistance caused by silicon oxide, so the brake light may stay on or the cruise control may shut off unexpectedly. Dealers replace the front brake switch.
Available Engines
Known Problems
On 2016-2020 FJRs, second gear can crack and break under high-speed loads, which can lock the transmission and the rear wheel. Yamaha's first recall inspected the bikes, reprogrammed the ECU and replaced the gearbox shafts where needed. That ECU programming could then stop the engine accelerating normally, so a second recall reprogrammed the ECU again. Bikes fixed under the first recall must go back for the second.
Shop parts for this repairSilicon oxide can build up on the front brake switch contacts and raise their resistance. The brake light can then stay on all the time, and the cruise control can switch off unexpectedly. Yamaha recalled 2013-2020 FJRs to replace the switch.
Shop parts for this repairThe FJR's shaft drive has a reputation for letting water in, and rust on the splines and joints causes clunks and wear if it's ignored. Buyers' guides recommend stripping and greasing the shaft and splines about every 30,000 miles, more often if the bike is ridden in the rain a lot.
Typical mileage: Every 30,000 miles
Shop parts for this repairA breather near the exhaust headers can draw water into the fuel tank, causing rough running or stalling in wet weather. Yamaha has an official fix, so check that it has been fitted on any used bike.
Shop parts for this repairWater pools under the tank, and the wiring and connectors there are prone to corrosion. Owners report intermittent electrical faults traced to this area. Cleaning and sealing the connectors with dielectric grease is cheap insurance.
Shop parts for this repairThe rear suspension linkage bearings can seize if they aren't cleaned and greased, making the ride harsh and wearing the shock. Check for notchy movement and grease the linkage when the rear wheel is out.
Shop parts for this repairThe electrically adjustable screen mechanism can break. Run it through its full travel when buying; it should move smoothly without grinding or stalling.
Shop parts for this repairRecalls
Second gear in the transmission of certain 2016-2020 FJR1300A and FJR1300AE models can crack and break under high-speed loads, which can lock the transmission and rear wheel. Dealers inspect the bike and, as needed, reprogram the ECU and replace the main axle and drive axle assemblies.
The ECU programming added by the second-gear recall can stop the engine from accelerating normally on certain 2016-2021 FJR1300s. Dealers reprogram the ECU, including on bikes already repaired under recall 20V-813.
Need help diagnosing your vehicle?
Get AI Diagnostic Report