Skip to content

Nissan 350Z Common Problems & Reliability Guide

car
2003–2009
1 generation3 OBD2 codes4 known problems1 recalls

Get Your FREE AI Diagnostic Report

Enter your year for a personalized diagnosis for your Nissan 350Z

Nissan 350Z

No account required · Takes 30 seconds

Overview

The Nissan 350Z (Z33) is a two-seat, rear-wheel-drive sports car sold in the US from the 2003 model year, as a coupe and a roadster, until the 370Z replaced it. It uses a 3.5L VQ V6: the VQ35DE through 2006, including a 300-hp tune in 2006 manual cars, and the VQ35HR from 2007. Known problems include excessive oil consumption in some VQ35DE engines, rapid inner-edge front tire wear on early cars, camshaft and crankshaft sensor failures that Nissan recalled, and failing power window motors.

Nissan 350Z service intervals, fluids and specs

Quick Summary

Most Common OBD2 Codes

P0340
Common
P0345
Common

Most Serious Issues

  • Excessive Oil Consumption (VQ35DE)
  • Camshaft and Crankshaft Position Sensor Failure

1 recall documented across all generations

By Generation

Available Engines

3.5L VQ35DE V6 (2003-2006)
3.5L VQ35HR V6 (2007-2009)

Common OBD2 Codes

CodeFrequencyNotes
P0340
Common
Camshaft position sensor circuit (bank 1); failed cam sensors cause stalling or a no-start and were part of Nissan's sensor recall.
P0345
Common
Camshaft position sensor circuit (bank 2); same sensor failure on the other bank.
P0335
Occasional
Crankshaft position sensor circuit; the crank sensor was also replaced under the recall.

Known Problems

Some VQ35DE engines, especially the "Rev Up" version in 2005-2006 cars, burn oil quickly; owners report about a quart every 1,000 miles or worse, starting at low mileage. Nissan issued a service bulletin, ran oil consumption tests and replaced engines in some cases, though some replacement engines also used oil. Check the oil level often, because running low can damage the engine.

Early 350Zs, especially 2003 models, wear the inner edges of the front tires quickly, with feathering, noise and vibration; some owners replaced front tires every 7,000 to 12,000 miles. Nissan extended coverage of front wheel alignment, and a class action settlement was later proposed for 2003-2004 cars. Some owners fitted aftermarket alignment kits.

Shop parts for this repair

Faulty solder joints inside the crank and cam position sensors can make the engine stall, lose power or refuse to start, with the check engine light on. Nissan recalled 2003 models to replace the sensors. Cam sensors on later cars also fail and are a common repair.

Related codes:P0340P0345P0335

Door window motors fail often, on either side, leaving a window stuck or slow. Owners report it from fairly low mileage onward, and replacing the motor or regulator is the usual fix.

Recalls

2003
Crankshaft and Camshaft Position Sensors May FailNHTSA

A solder joint on the circuit board of the crank and cam position sensors may fail from heat stress, causing a check engine light, no-start, reduced power or a stall while driving. Dealers replace the crank and cam position sensors.

Need help diagnosing your vehicle?

Get AI Diagnostic Report