Lincoln Town Car Common Problems & Reliability Guide
Get Your FREE AI Diagnostic Report
Enter your year for a personalized diagnosis for your Lincoln Town Car
Overview
This page covers the Lincoln Town Car sold from the 1998 to the 2011 model year, a rear-drive body-on-frame sedan with a 4.6L V8 and a four-speed automatic. Output ran from 200 to 240 hp depending on trim and year through 2002, and every Town Car from 2003 on has 239 hp. The best-known problems are the plastic intake manifold on 1998-2001 cars, which can crack and leak coolant, and leaks in the rear air suspension that leave the car sagging and wear out the compressor.
Quick Summary
Most Serious Issues
- Cracked Plastic Intake Manifold (1998-2001)
1 recall documented across all generations
By Generation
Available Engines
Known Problems
The 4.6L V8 in 1998-2001 Town Cars has a plastic intake manifold that carries engine coolant through it. The coolant passage at the front of the manifold, near the thermostat housing, can crack and leak, and the car can lose coolant and overheat. Ford settled a class action over these manifolds in 2005 and reimbursed owners for past repairs. A sweet coolant smell, wet residue at the front of the engine or a falling coolant level are the signs to look for.
The Town Car uses air springs at the rear. As the rubber air springs age, they leak, the rear of the car sags, and the compressor has to run longer to keep up until it wears out. A car that sits low at the rear after being parked overnight, or a compressor that runs often, points to a leak.
Recalls
On cars with cruise control, the speed control deactivation switch can leak internally and then overheat, smoke or burn, which could cause an underhood fire. Dealers install a fused wiring harness.
Need help diagnosing your vehicle?
Get AI Diagnostic Report