KTM 990 Adventure Common Problems & Reliability Guide
Get Your FREE AI Diagnostic Report
Enter your year for a personalized diagnosis for your KTM 990 Adventure
Overview
The KTM 990 Adventure replaced the carbureted 950 Adventure in 2006, with the LC8 V-twin bored out to 999cc and switched to fuel injection. It was updated for 2009, when the off-road S model became the R, and the 1190 Adventure replaced it in 2013. Many owners cover big miles on them without trouble, but the same few parts come up again and again: the clutch slave cylinder, the water pump shaft and seals, and rusting spokes. Check the service history on any used bike. This guide covers the 2006-2013 990 Adventure, S and R.
By Generation
Available Engines
Known Problems
The hydraulic clutch slave cylinder seal is the LC8's best-known weak point. It failed often on the 950, and some 990s have had the same leak. Look for fluid weeping around the slave cylinder and a clutch that feels soft or doesn't fully disengage. Rebuild kits and stronger aftermarket slave cylinders are both available.
The water pump shaft and seals are the other common failure point. A worn seal lets coolant leak out or get into the engine oil. Watch for the coolant level dropping, a milky or soggy oil filter, or coolant at the pump's weep point. The repair is a new seal, shaft and bearings plus a clutch cover gasket, and some owners replace the seals before they fail.
Rusty spokes are the most common complaint about the finish. Check every spoke and nipple for corrosion, and check spoke tension, especially on bikes that have been ridden off-road or through winter roads. Be careful with anti-rust sprays, because overspray on the brake discs will spoil braking.
Recalls
On 2007 990 Adventure and Adventure S bikes, an assembly error means the chain slider guard mounting bolt can work loose and fall out. The guard could then catch in the drive chain and cause a crash. Dealers inspect the bolts and secure them properly.
Need help diagnosing your vehicle?
Get AI Diagnostic Report