Skip to content

BMW R 1150 GS Common Problems & Reliability Guide

motorcycle
2000–2004
1 generation4 known problems2 recalls

Get Your FREE AI Diagnostic Report

Enter your year for a personalized diagnosis for your BMW R 1150 GS

BMW R 1150 GS

No account required · Takes 30 seconds

Overview

The BMW R 1150 GS replaced the R 1100 GS and was sold in the US from 2000 to 2004, with the long-range GS Adventure added during its run. It uses a 1,130cc air/oil-cooled boxer twin with shaft drive and was the first GS with a six-speed gearbox. Later bikes got twin-spark heads and BMW's servo-assisted integral ABS brakes. The engine itself is very reliable and bikes with over 70,000 miles are common, so most trouble comes from the parts around it: final drive bearings, the clutch slave cylinder, fuel hoses inside the tank and the servo ABS unit. Two US recalls cover brake lines. This guide covers the 2000-2004 GS and the GS Adventure.

BMW R 1150 GS service intervals, fluids and specs

Quick Summary

Most Serious Issues

  • Final Drive Bearing Failure($400-$700 for bearings caught early; much more for a replacement final drive)
  • Clutch Slave Cylinder Leaks and Clutch Contamination($100-$250 for a slave cylinder; $800-$1,300 if the clutch has to be replaced)
  • Servo ABS Unit Failure($1,000+ for a replacement ABS modulator)

2 recalls documented across all generations

By Generation

Available Engines

1,130cc air/oil-cooled boxer twin, fuel-injected, six-speed, shaft drive

Known Problems

The bearings in the Paralever final drive are the GS's best-known mechanical failure. In one owner survey seven riders had a final drive bearing go, at 25,000 to 45,000 miles, and other owners report the crown wheel bearing failing. Early signs are a grumbling noise from the rear and slightly higher fuel consumption. Check for noise, play at the rear wheel and oil weeping from the final drive or swingarm seal. Caught early, it's a bearing job. Left alone, it can wreck the final drive.

Typical mileage: 25,000-45,000 miles

Shop parts for this repair

The hydraulic clutch slave cylinder sits behind the gearbox and can leak. Owners report a leaking slave soaking the dry clutch and ruining the gearbox seal behind it. Wear on the gearbox input shaft is another cause of clutch trouble, and one owner had a gearbox spline go at about 45,000 miles. Any clutch replacement means splitting the bike in half to separate the gearbox from the engine, so feel for slip on a test ride and look for fluid around the bottom of the gearbox.

Shop parts for this repair

Later bikes have BMW's servo-assisted integral ABS. Owners report the brake servo failing, and when the ABS system fails the repair bill is high. Check that the ABS self-test completes and the warning lights go out, and make sure the brake fluid has been changed on schedule.

Shop parts for this repair

The fuel pump sits inside the tank, and the rubber fuel hoses in there age and break down. Owners report having to replace them, so check the service history for it.

Shop parts for this repair

Recalls

2002
Speedometer Cable May Chafe Front Brake LineNHTSA

On R 1150 GS bikes built from May 1999 to June 2001, the speedometer cable can sit too close to the front brake line and chafe it as the fork moves. The line could leak and the front brake lose effectiveness. Dealers check the clearance, replace the brake line if it is too close or damaged, and fit a protective sleeve to the speedometer cable.

2003
R 1150 GS Adventure Rear Brake Hose May SplitNHTSA

On 2003 R 1150 GS Adventure bikes built from May 2002 to April 2003, the rear brake hose material, sometimes made worse by incorrect routing, can split when the rear suspension fully extends, causing loss of rear braking. Dealers replace and reroute the hose.

Need help diagnosing your vehicle?

Get AI Diagnostic Report