Skip to content

P2291

Powertrain
Moderate

Injector Control Pressure Too Low - Engine Cranking

What could P2291 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P2291 means the engine computer saw injector control pressure drop below the manufacturer's limit while the engine was cranking. It is a diesel code. On engines with a high-pressure oil system, oil pressure is what pushes the injectors open, so if that pressure is too low the engine will not start or will start poorly.

The first thing to check is the oil level, because low or leaking oil is a common reason for this code. After that, the pressure sensor, the pressure regulator, and the wiring are the usual suspects. Running the engine for a long time with the code stored can cause serious engine damage, so do not ignore it.

If the engine starts, check the oil and look for leaks. If the oil level is fine or the engine will not start, get it diagnosed. This code is hard to separate from a failing high-pressure oil pump or injector leak without pressure testing, so a shop with diesel experience is usually worth the cost.

Severity

High — Immediate AttentionWithin 24 Hours

Symptoms

  • •Check Engine Light illuminated
  • •Long crank or no-start condition
  • •Hard starting when cold
  • •Engine stumbles or stalls after starting
  • •Low engine oil level or visible oil leaks

Likely Causes

Low engine oil level or oil leak30%

On diesels that use high-pressure oil to fire the injectors, low or leaking oil keeps injector control pressure from building while cranking.

Faulty injector control pressure (ICP) sensor25%

If the sensor reads low or fails, the computer sees a pressure shortfall that may not exist.

Faulty injection pressure regulator or high-pressure oil pump25%

A regulator stuck open or a worn pump cannot build the oil pressure the injectors need to fire.

Damaged wiring or connector at the sensor or regulator15%

Chafed, corroded or loose connections cause a false low reading or poor regulator control.

Failed powertrain control module5%

Rare, and only after everything else has been tested.

Estimated Cost

DIY Repair

$30–$500
Difficulty
Shop OBD2 scanners

Professional Repair

$200–$1800

Includes parts + labor

Common Fixes

  1. Check engine oil level and correct any low-oil condition
  2. Find and repair oil leaks, including injector and high-pressure oil system O-rings
  3. Replace the injector control pressure sensor
  4. Replace the injection pressure regulator
  5. Repair wiring or connectors at the sensor and regulator

Shop Parts

Related Codes

Still have questions about P2291?

Continue with P2291

Next: add your vehicle and symptoms. Your code carries over.