Skip to content

P0971

Powertrain
Moderate

Pressure Control Solenoid C Control Circuit High

What could P0971 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0971 means the transmission computer sees high voltage on the control circuit of pressure control solenoid C. On some transmissions an open circuit sets this code as well as a short to voltage. Solenoid C sets the pressure to one or more clutches, and what it feeds depends on the transmission.

On GM six-speed automatics, for example, the computer commands maximum line pressure, freezes shift adaptation and limits the transmission to reverse and a reduced set of forward gears (reverse and fifth only on the front-drive 6T70 and 6T75). There the solenoid is part of a control solenoid valve assembly with no serviceable parts, so the fix is usually that assembly.

Check the connector and wiring first, since a loose connection can make the code come and go. Limp mode is meant to get you to a shop, not for regular driving.

Severity

High — Immediate AttentionWithin 24-48 Hours

Symptoms

  • •Check engine light on
  • •Limp mode in a fixed gear
  • •Harsh engagements from maximum line pressure
  • •Missing forward gears
  • •Fault may come and go with heat or vibration

Likely Causes

Open circuit or poor connection at the solenoidMost common

On some transmissions an open or high-resistance control circuit is reported as a high-voltage fault, often from a loose connector or a failed solenoid coil.

Control circuit shorted to voltageCommon

A control wire touching a power circuit holds the signal high.

Damaged transmission connector or internal harnessCommon

Damaged or loose pins at the transmission connector can make the fault come and go.

Control solenoid or module assembly faultLess common

On designs where the solenoids and the transmission computer are one assembly, a fault inside it means replacing the assembly.

Estimated Cost

DIY Repair

$100–$600
Difficulty
Shop OBD2 scanners

Professional Repair

$300–$1800

Includes parts + labor

Common Fixes

  1. Inspect the transmission connector for damage, looseness and fluid
  2. Check the solenoid C control circuit for opens and shorts to voltage
  3. Replace pressure control solenoid C, or the solenoid body assembly that contains it
  4. Reset transmission adaptations after the repair

Shop Parts

Related Codes

Still have questions about P0971?

Continue with P0971

Next: add your vehicle and symptoms. Your code carries over.