Skip to content

P0966

Powertrain
Moderate

Pressure Control Solenoid B Control Circuit Low

What could P0966 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0966 means the transmission control module sees a low voltage condition in the control circuit for pressure control solenoid B. This solenoid helps regulate hydraulic pressure to clutches in an automatic transmission. The exact solenoid that 'B' refers to varies by manufacturer.

The code is more often electrical than mechanical, but the result can still be harsh or flared shifts and extra wear on the clutches. If the pressure problem continues, the transmission can be damaged enough to need replacement.

You can usually drive the car for a short time, but plan to get it checked this week. Start with the fluid level and condition, then check the wiring and connector at the transmission. If those look fine, a shop can test the solenoid and circuit.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Harsh or flaring upshifts
  • •Shifts that feel delayed or shocking
  • •Reduced fuel economy
  • •Transmission may go into limp mode on some vehicles

Likely Causes

Open or short in the solenoid B wiring or connector35%

The code points at the control circuit, so damaged wires, chafed harness sections, or corroded connectors at the transmission are the most common finds.

Failed pressure control solenoid B30%

The solenoid coil can fail open or short, which pulls the circuit voltage out of range and sets the code.

Low, old, or contaminated transmission fluid20%

Metal and clutch debris can foul solenoids and valve bodies, and low fluid can lead to pressure faults.

Valve body or hydraulic problem10%

Worn or sticking valves can mimic a solenoid fault, though they usually set range/performance codes first.

Transmission control module fault5%

A failed driver circuit inside the TCM is possible but uncommon.

Estimated Cost

DIY Repair

$30–$400
Difficulty
Shop OBD2 scanners

Professional Repair

$200–$1200

Includes parts + labor

Common Fixes

  1. Repair damaged wiring or connectors at the transmission
  2. Replace pressure control solenoid B
  3. Service the transmission fluid and filter
  4. Repair or replace the valve body
  5. Replace or reprogram the TCM

Shop Parts

Still have questions about P0966?

Continue with P0966

Next: add your vehicle and symptoms. Your code carries over.