Skip to content

P0729

Powertrain
Moderate

Gear 6 Incorrect Ratio

What could P0729 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0729 means the transmission control system found that the ratio between the input and output shaft speeds does not match what it expects in sixth gear. The code only applies to transmissions with at least six forward gears. The TCM or PCM compares the speed sensor readings to the gear it commanded, and sets the code when they disagree.

The usual causes are low or worn fluid, internal wear that lets clutches slip, or a valve body or solenoid problem. A wiring or speed sensor fault can also trigger it. Some vehicles show no symptoms beyond the light, while others slip, shift poorly, or use more fuel. Continued slipping can damage the transmission.

Check the fluid level and condition first, since that is cheap and often the cause. If the fluid is fine, have the speed sensors, wiring and solenoids tested before assuming internal damage. Have it looked at within a week and avoid heavy loads or towing until then.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check Engine Light illuminated
  • •Transmission slipping in or near sixth gear
  • •Improper or erratic shifting
  • •Higher engine RPM at highway speed
  • •Decreased fuel economy
  • •Transmission may default to a fixed gear (limp mode)

Likely Causes

Low or degraded transmission fluid30%

Low or worn fluid reduces hydraulic pressure, so clutches slip and the TCM sees a gear ratio that does not match sixth gear.

Worn clutches or other internal transmission damage25%

Slipping clutch packs in the gear 6 path change the input to output speed ratio.

Faulty valve body or shift solenoid20%

Sticking valves or failed solenoids cannot apply the correct clutches for sixth gear.

Wiring or speed sensor problem15%

Bad input or output speed sensor signals can make the TCM calculate a wrong ratio.

Faulty TCM or PCM10%

Rare, but a failing control module can misread or mis-command gear ratio.

Estimated Cost

DIY Repair

$40–$250
Difficulty
Shop OBD2 scanners

Professional Repair

$150–$3500

Includes parts + labor

Common Fixes

  1. Check fluid level and condition, then replace fluid and filter
  2. Inspect and test input and output speed sensors and wiring
  3. Service or replace the valve body or shift solenoids
  4. Repair or rebuild the transmission if internal clutches are worn
  5. Update or replace the TCM only after other causes are ruled out

Shop Parts

Related Codes

Still have questions about P0729?

Continue with P0729

Next: add your vehicle and symptoms. Your code carries over.