Skip to content

P06DD

Powertrain
Moderate

Engine Oil Pressure Control Circuit Performance/Stuck Off

What could P06DD mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P06DD is set on engines with a switchable oil pump. These pumps run at a lower pressure most of the time to save fuel and switch to high pressure when the engine needs it. A solenoid valve controlled by the engine computer does the switching, and with no power the pump defaults to high pressure. To test it, the computer switches the valve and watches the oil pressure sensor. P06DD means the pressure didn't respond and stayed high, as if the valve were stuck off. GM and Ford both use such pumps.

A stuck or dirty control valve is the most common cause, but don't assume it. GM found that on some 2014 to 2019 V8 and 4.3L V6 engines, a timing chain tensioner guide could damage the oil pump, and the code then came with low oil pressure. Low or old oil, a damaged pump drive and a bad pressure sensor can also stop the pressure from changing.

Check the oil level first and confirm actual oil pressure with a gauge. If pressure is low or erratic, stop driving and get it diagnosed, because low oil pressure can quickly damage bearings.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on
  • •Oil pressure reading stays high and doesn't change with engine speed
  • •Low or fluctuating oil pressure when the pump or its drive is damaged
  • •Oil pressure warning on some vehicles
  • •Slightly worse fuel economy

Likely Causes

Oil pump control valve stuck or its screen cloggedMost common

On engines with a two-stage or variable oil pump, a solenoid valve switches the pump between pressures. If it sticks, the pressure stays at the high, unpowered setting and the computer sees no change when it switches the valve.

Low oil level, wrong oil or sludgeCommon

The control valve and pump need clean oil of the right grade to switch cleanly.

Damaged oil pump or pump driveCommon

On 2014 to 2019 GM V8 and 4.3L V6 trucks and cars, GM found a timing chain tensioner guide whose spring could damage the oil pump face, which also stops the pressure from responding.

Control valve not seated correctlyLess common

A valve that wasn't fully seated or clipped in after earlier work can't control the pump.

Inaccurate oil pressure sensorLess common

The test relies on the oil pressure sensor, so a sensor that reads wrong can set the code on a healthy pump.

Estimated Cost

DIY Repair

$50–$400
Difficulty
Shop OBD2 scanners

Professional Repair

$200–$3500

Includes parts + labor

Common Fixes

  1. Check the oil level and grade, and change the oil if it is old or sludged
  2. Confirm real oil pressure with a mechanical gauge before replacing parts
  3. Test, clean or replace the oil pump control valve
  4. On affected GM V8 and 4.3L engines, inspect the timing chain tensioner guide and the oil pump face
  5. Replace the oil pump if its face or drive is damaged

Shop Parts

Related Codes

Still have questions about P06DD?

Continue with P06DD

Next: add your vehicle and symptoms. Your code carries over.