Skip to content

P0544

Powertrain
Moderate

Exhaust Gas Temperature Sensor Circuit (Bank 1 Sensor 1)

What could P0544 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0544 means the powertrain control module has found a problem in the exhaust gas temperature (EGT) sensor circuit for bank 1, sensor 1. The PCM reads the sensor voltage as a temperature, and the code sets when that voltage falls outside the range the manufacturer programmed. It is separate from the oxygen sensors, so replacing an O2 sensor will not clear it.

Most of the time the only symptom is the Check Engine Light. The car is generally safe to drive, but the PCM relies on this sensor. It may change timing or fuel mixture to protect the catalytic converter, and a long-ignored fault can lead to heat damage there.

Start with the wiring and connector at the sensor, since damaged or corroded terminals are the most common cause. If those are fine, test the sensor itself. Shop diagnostic fees alone often run about $150, so a sensor or wiring repair at a shop usually lands in the low hundreds. Costs vary by vehicle and location.

Severity

Moderate — Address SoonThis Month

Symptoms

  • •Check Engine Light illuminated
  • •Often no other noticeable symptoms
  • •Reduced engine power on some vehicles
  • •Higher fuel consumption on some vehicles
  • •Rough or unstable idle on some vehicles

Likely Causes

Damaged, corroded or loose wiring, connector or terminals45%

Broken, burnt or corroded wiring and terminals are described as the most common cause of EGT circuit codes.

Failed exhaust gas temperature sensor30%

The sensor can be shorted internally or to ground, or simply defective, which pushes its voltage outside the range the PCM expects.

Aftermarket or off-road exhaust causing pressure problems10%

Non-stock exhaust systems can create back pressure that affects readings.

Large exhaust leak upstream of the sensor10%

A big leak ahead of the sensor can change the temperature it sees.

PCM fault5%

Rare, and only worth checking after the wiring and sensor test good.

Estimated Cost

DIY Repair

$30–$150
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$100–$300

Includes parts + labor

Common Fixes

  1. Inspect and repair wiring, connectors and terminals at the EGT sensor
  2. Test the sensor resistance and signal against factory specs
  3. Replace the EGT sensor if it is out of spec
  4. Repair any large exhaust leak upstream of the sensor
  5. Clear the code and recheck that it does not return

Shop Parts

Related Codes

Still have questions about P0544?

Continue with P0544

Next: add your vehicle and symptoms. Your code carries over.