Skip to content

P0499

Powertrain
Low

Evaporative Emission System Vent Valve Control Circuit High

What could P0499 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0499 means the control circuit for the EVAP canister vent valve is reading high, usually because the control wire is shorted to voltage. With that fault the engine computer can't close the valve, so it can't seal the EVAP system to run its leak tests.

You usually won't notice anything while driving, but the EVAP readiness monitor won't set, which can fail an emissions test. General Motors is the main user of this code scheme; Ford reports vent valve faults as P0446.

A wiring repair or a new vent valve fixes most cases.

Severity

Low — MonitorThis Month

Symptoms

  • •Check engine light on
  • •EVAP readiness monitor not set
  • •Usually no change in driving

Likely Causes

Control wire shorted to battery voltageMost common

A chafed harness lets the control wire touch a power source, so the computer can't switch the valve.

Vent valve coil with shorted turnsCommon

A partly shorted coil makes the driver switch off to protect itself.

Moisture or corrosion in the connectorCommon

The valve's location near the canister exposes it to water.

Driver in the engine computerLess common

Rarely, the computer's output for the vent valve fails.

Estimated Cost

DIY Repair

$20–$120
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$80–$280

Includes parts + labor

Common Fixes

  1. Inspect the vent valve wiring for a short to voltage
  2. Clean or repair the vent valve connector
  3. Replace the EVAP canister vent valve

Shop Parts

Related Codes

Still have questions about P0499?

Continue with P0499

Next: add your vehicle and symptoms. Your code carries over.