Skip to content

P0197

Powertrain
Moderate

Engine Oil Temperature Sensor A Circuit Low

What could P0197 mean for your vehicle?

Add your vehicle to explore possible causes and next checks. AI guidance helps you investigate; it does not confirm a diagnosis.

Next: review your vehicle and symptoms. Your code carries over. No account needed to start.

P0197 means the signal from engine oil temperature sensor A is below its valid range. The sensor is a thermistor fed with 5 volts: hotter oil means lower resistance and lower voltage. A signal near zero reads as oil much hotter than is realistic.

The usual cause is a short, either the signal wire chafed against ground or a sensor that has shorted inside. Oil or water in the connector can do the same. Not every engine has this sensor, and whether the warning light comes on depends on the maker and model year.

The engine computer uses the oil temperature for engine protection, oil life and, on some engines, variable valve timing, so it may limit those functions. Confirm the engine isn't actually overheating, then check the wiring before replacing the sensor.

Severity

Moderate — Address SoonThis Week

Symptoms

  • •Check engine light on (on many vehicles)
  • •Oil temperature gauge or reading at maximum
  • •Oil temperature warning possible
  • •Cooling fan running constantly on some vehicles
  • •Variable valve timing or power limited on some engines

Likely Causes

Signal wire shorted to groundMost common

A wire chafed against the engine block or another ground pulls the signal voltage down, which the computer reads as very hot oil.

Failed oil temperature sensorCommon

A sensor shorted inside reads extremely low resistance and sets the same low-voltage fault.

Oil or water in the connectorCommon

Oil or water in the connector can leak the signal to ground.

Actually overheated oilLess common

Genuinely very hot oil lowers the sensor's resistance, so confirm the engine isn't overheating.

Engine computer faultLess common

Rarely, the computer's input or its 5-volt reference is at fault.

Estimated Cost

DIY Repair

$20–$150
Difficulty

DIY Friendly

Shop OBD2 scanners

Professional Repair

$100–$350

Includes parts + labor

Common Fixes

  1. Check the oil temperature reading with a scan tool and confirm the engine isn't really overheating
  2. Inspect the sensor connector for oil, water and corrosion
  3. Check the signal wire for a short to ground
  4. Replace the engine oil temperature sensor if the wiring tests good

Shop Parts

Related Codes

Still have questions about P0197?

Continue with P0197

Next: add your vehicle and symptoms. Your code carries over.